RED ORCHIDEA Instrukcje Operacyjne Pobierz pdf (Strona 29)

red

PELLET STOVES Chapter 4

INSTALLATION AND USE MANUAL

page 29

Operation Technical service - Rights reserved - Reproduction prohibited

4.2. DISPLAY PANEL AND COMMANDS

4.2.1. Control panel logic

Shown below is some useful information for understanding the logic

and use of the control panel:

 Knob A has 5 ventilation levels. The knob rotates uniformly

from min to max.

 Knob B allows the room temperature to be regulated. The

temperature ranges from a minimum of 15°C to a maximum of

30°C, also in this case the knob turns uniformly.

 Knob C foresees 5 levels of flame regulation (power); the key

rotates uniformly.

 Key D allows the stove to be ignited (ON) or shutdown (OFF).

 Key E increases or decreases pellet load respect to the factory

default value which is 0. When the stove is lit for the first

time, the set setting is 0 (led in the middle), by using key E

you increase (led to the right+1/+2) or decrease (led to the

left-1/-2) the pellet load. The selected led will remain fixed

orange while the stove is operational, it will go out when the

stove is switched off and the last setting will stay in the

memory when it is lit again.

 Led 1 – when the stove is lit the led is green and fixed,

flashing green when igniting/setting the stove and flashing

yellow/orange when it is switched off; it flashes red in the case

of the intervention of an alarm.

 The 5 leds over key E (0/-1/-2/+1/+2) also light up to signal

alarms. In the event of alarm, Led 1 will flash red, there will

be an acoustic signal and the type of alarm is identified by one

of the five corresponding Leds.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Brak uwag

RED ORCHIDEA Instrukcje Operacyjne Strona 29